Powerful dual battery power supply with 7 channels, voltage regulators and telemetry.

Features

• 7 channels
• 12 outputs
• High-performance battery backer with high continuous load capacity
• All power electronics duplicated
• Redundant electronic switch
• Four selectable output voltages: 6.0V, 7.4V, 7.8V or unregulated
•  

Telemetry data for PowerBox P²BUS, Futaba S.BUS2, Jeti Ex-BUS, Spektrum, SRXL2, Multiplex M-Link, JR X-BUS and Graupner HoTT

All features can be controlled from PowerBox and Jeti transmitters

Signal amplification for all 12 outputs

Voltage indication by means of tri-colour LEDs

Supports four battery types: LiPo, LiIon, NiMh/NiCd, LiFe

Servo feedback current suppression

Machined high-performance heat-sink for optimised heat dissipation

Machined, anodised aluminium switch case

Compact format

Technical Data : 

Operating voltage :  4.0V - 9.0V

Power supply :  2S LiPo, 2S Lilon, 2S LiFePo, 5S NiMH

Current drain Power-on state :  66mA

Current drain Standby : 8μA

Maximum load current :  2x10 A (<30s 2x 40A)

Drop-out voltage :  0.3V

Output voltage :  6.0V, 7.4V, 7.8V, unregulated

Signal input :  PWM

Supported RC systems :  PowerBox, Jeti, Futaba, Multiplex, JR, Graupner, S

Channels : 7

Servo sockets : 12

Supported telemetry systems : P²BUS, S.BUS2, EX-BUS, SRXL2, M-Link, Hott, JR-DMS

Dimensions : 89 x 55 x 18 mm

Weight : 69g

Weight Sensor Switch : 8g

Temperature range : -30°C bis +105°C

Set contents

• PowerBox Evo
• MicroSwitch
• 8x patch leads
• 6x fixing screws
• 4x rubber grommets and brass sleeves
• Operating instructions
• Product description

The PowerBox Evo is an ultra-compact dual power supply featuring 7 channels, regulated output voltage and telemetry. The 7 inputs are assigned to 12 outputs, allowing two servos to be controlled in parallel on each of 3 channels, without requiring additional Y-leads. All servo outputs have integral signal amplification and are protected against servo feedback currents.

The PowerBox MicroSwitch included in the set is not subject to wear, and operates both electronic switches reliably. It is also used to set the output voltage and the battery type.

By default the two high-performance voltage regulators deliver 6.0V, but that value can easily be changed to 7.4V, 7.8V or no regulation at all using the PowerBox MicroSwitch. The machined aluminium heat-sink ensures a high continuous load capacity.

The PowerBox Evo supports all current telemetry systems: PowerBox, Jeti, Futaba, Multiplex, Graupner, Spektrum and JR, which means that the voltage of both batteries can be monitored conveniently from the transmitter. It is also possible to read off the state of charge of the batteries at any time using the two tri-colour LEDs.